New Beetle GL L4-2.0L (AZG) (2002)
Basic setting
Input display group number XXX
-
Press buttons 0, 4 and 3 for "Display group number 34" and confirm entry with Q button.
Indicated on display (1-4 = Display zones)
System in basic setting 43
->
1
2
3
4
-
Set engine speed to at 2300 RPM using the speed regulator V.A.G 1788/10:
-
Maintain engine speed at 2300 RPM until display in display zone 4 jumps from "Test OFF" to "Test ON". Catalyst temperature in display zone 2
must be at least 365 °C
-
Continue to maintain speed at 2300 RPM until specification "B1-S1 OK" appears in display zone 4.
If the specification is not obtained:
-
Press -> button.
-
Press buttons 0 and 6 for function "End output" and confirm entry with Q button.
-
Switch ignition off.
If the specifications are not attained:
-
Carry out a road test to free oxygen sensor of possible residues and repeat the test.
Observe the valid safety precautions when carrying out a road test.
If the specifications are again not attained:
-
Replace oxygen sensor before catalyst (G39)
-
Check DTC memory, if necessary, repair any malfunctions and then erase DTC memory. Refer to "Displaying and Reading Trouble Codes/With
Manufacturers Scan Tool/DTC Memory Checking and Erasing" See: Testing and Inspection
-
Read readiness code. If DTC memory has been erased or engine control module was disconnected from permanent positive, readiness code must
be generated again.
Refer to "Monitors, Trips and/or Drive Cycle/Readiness Code, Displaying" See: Testing and Inspection
Refer to "Monitors, Trips and/or Drive Cycle/Readiness Code, Generating" See: Testing and Inspection