New Beetle GL L4-2.0L (AZG) (2002)
identification, activate cruise control system. See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting
Vehicles with automatic transmissions:
Learning kick-down point
-
Adapt control module for automatic transmission.
Continued for all vehicles
-
Check DTC memory, if necessary, repair any malfunctions and then erase DTC memory, checking and erasing DTC memory. See: Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
-
Perform idle check. See: Fuel Delivery and Air Induction/Idle Speed/Testing and Inspection
-
Test drive vehicle.
Observe the valid safety precautions when performing a road test. See: Fuel Delivery and Air Induction/Fuel Injector/Service Precautions/Technician
Safety Information
During the road test the following operating conditions must be fulfilled:
-
The coolant temperature must exceed 80 °C.
-
When the temperature is reached, the operating conditions
Idling
Part throttle
Enrichment
Wide open throttle
Overrun
must be obtained several times.
-
Check DTC memory, if necessary, repair any malfunctions and then erase DTC memory, checking and erasing DTC memory. See: Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
With Generic Scan Tool
Replacing Engine Control Module (ECM)
Work procedure
First, check control module identification of the previous Engine Control Module (ECM) as follows:
-
Connect diagnostic tester.
-
Switch ignition on.
-
Under address word 33, select "Diagnostic mode 9: vehicle information".
-
Select the vehicle information "Test-ID 04: Calibration Identification".
-
Control module identification will be indicated, e.g.: 06A906032KC 4795
-
End diagnosis and switch ignition off.