New Beetle GL L4-2.0L (AZG) (2002)
-
Using multimeter and adapter cables from V.A.G 1594, measure supply voltage between terminals 1 + 6 of disconnected connector.
-
Switch ignition on.
Specification: min. 11.5 V
-
Switch ignition off.
If no voltage is present:
-
Check wiring for open circuit between 6-pin connector terminal 6 and Motronic current supply relay (J271) using wiring diagram.
Wire resistance: max. 1.5 Ohms
-
Check wire between 6 pin connector terminal 1 and Ground (GND) for open circuit according to wiring diagram.
Wire resistance: max. 1.5 Ohms
If there is no fault in the supply voltage:
-
Check activation
Checking activation
WARNING!
During the following test do not touch the connecting parts of the ignition coils or test cables.
-
Remove fuse 32
NOTE: Removing fuse 32 interrupts the voltage supply to the injectors.
-
Disconnect 6-pin connector from ignition coils with power output stage (N70, N127, N291, N292) -arrow-.