New Beetle GL L4-2.0L (AZG) (2002)
Camshaft Position Sensor: Testing and Inspection
With Generic Scan Tool
Check Camshaft Position (CMP) sensor
Recommended special tools and equipment
-
VAG1526 multimeter or VAG1715 multimeter
-
VAG1594 connector test kit
-
Wiring diagram
Test requirements
-
The respective fuses of Motronic Engine Control Module (ECM) -J220- must be OK.
-
Battery voltage must be at least 11.5 volts.
-
All electrical consumers such as, for example, lights and rear window defroster must be switched off.
-
Parking brake must be engaged or else daylight driving lights will be switched on.
-
Ground (GND) connections between engine and chassis must be OK.
Test sequence (Vehicles with engine code AEG)
Test sequence (Vehicles with engine code AVH, AZG, BDC).
-
Remove engine cover.
-
Disconnect the 3-pin connector from Camshaft Position (CMP) Sensor -G40- (arrow).