New Beetle GL L4-2.0L (AZG) (2002)
-
Unscrew protective cover (arrows) and disconnect 4-pin harness connector (brown) -1- to Oxygen Sensor (O2S) behind Three Way Catalytic
Converter (TWC) -G130-.
Vehicles with engine code AEG, AVH, AZG
-
Check resistance for sensor heater at connector to oxygen sensor terminal 1 + 2. Specified value: 1.0...5.0 Ohms (at room temperature)
Vehicles with engine code BDC
-
Check resistance for sensor heater at connector to oxygen sensor terminal 1 + 2. Specified value: 8.0...20.0 Ohms (at room temperature)
Continuation for all vehicles
If specified value is not obtained:
-
Replace Oxygen Sensor (O2S) 2 Bank 1 Behind Three Way Catalytic Converter (TWC) -G130-.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified value is obtained:
-
Check Ground (GND) activation of oxygen sensor heater.
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring
Test
Vehicles with engine code AEG