New Beetle GL L4-2.0L (AZG) (2002)
Vehicle Speed Sensor: Testing and Inspection
With Generic Scan Tool
Speed Signal, Checking
Recommended special tools and equipment
-
VAG 1526 multimeter or VAG 1715 multimeter
-
VAG 1594 connector test kit
-
Wiring diagram
Test requirements
-
The respective fuses of Motronic Engine Control Module (ECM) -J220- must be OK.
-
Battery voltage must be at least 11.5 volts.
-
Speedometer -G21- must be OK.
Test sequence
NOTE: To test speed signal, vehicle must be driven. Doing this requires a second person.
WARNING: Secure Scan Tool (ST) on the rear seat and have operated from there by second technician.
-
Connect diagnostic tester. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Diagnostic Tester, Connecting
-
Start engine and let run at idle.
-
Under address word 33, select "Diagnostic mode 1: Checking measured values."
-
Select the measuring value "PID 13: Vehicle speed".
-
Perform a road test, while a 2nd person observes the indication on the display.
-
Check specified value of the vehicle speed:
-
End diagnosis and switch ignition off.
If no speed is indicated:
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box,
Connecting For Wiring Test
Vehicles with engine code AEG
-
To measure voltage, connect multimeter between sockets 2 (Ground -GND-) + 20 (speed signal) of test box.
Vehicles with engine code AVH, AZG, BDC
-
To measure voltage, connect multimeter between sockets 2 (Ground -GND-) +54 (speed signal) of test box.