New Beetle GL L4-2.0L (AZG) (2002)
-
On vehicles without ABS, remove bolts -1- and -2- for brake pressure regulator.
-
Place VAG1383A engine/transmission jack in position.
-
Remove mounting bracket bolts -1- on rear axle from both sides and lower rear axle.
Installing
Installation is the reverse of removal.
After installing:
-
Bleed brakes.
-
Check position of steering wheel during test drive.
If steering wheel is not in straight ahead position:
-
Check wheel alignment.
Fastener/location - Tightening torque
Shock absorber to body: ...................................................................................................................................................................... 75 Nm (55 ft. lbs.)
Use new bolts!
Mounting bracket to rear axle: ............................................................................................................................................................ 80 Nm (59 ft. lbs.)
Use new nuts and bolts!