New Beetle GL L4-2.0L (AZG) (2002)
/Page-1110003.png)
-
Remove bolts -1- with vehicle standing on its wheels (raise vehicle until bolts are accessible).
-
Raise vehicle further (to relieve coil spring pressure).
-
Remove shock absorber hex bolt -1- on rear axle.
Note:
-
For a clearer illustration the vehicle is shown without the wheel installed.
-
Remove shock absorber.
Installation is the reverse of removal.
Fastener/location - Tightening torque
Shock absorber to rear axle: ................................................................................................................................................................ 60 Nm (44 ft. lbs.)
Use new nuts!
Load rear of vehicle with weight of one person when tightening
Shock absorber to body: ...................................................................................................................................................................... 75 Nm (55 ft. lbs.)
Use new bolts!
Shock Absorber Assembly Overview
Shock Absorber Assembly Overview
