New Beetle GL L4-2.0L (AZG) (2002)
^
Press master cylinder fully in direction of arrow -1
It must not be covered in upper area by overcenter spring mounting (arrow -2-).
^
Remove it from support in direction of arrow -3-.
Installing
Installation is carried out in the reverse sequence. When installing note the following:
^
Retainer -A- must be on clutch master cylinder operating rod -B-.
^
Push clutch pedal in direction of arrow to engage it, and make sure it is located correctly.
^
Fit stop -A- for clutch pedal.
Installation position:
The arm (arrow) points toward the master cylinder -B-.
^
After installing clutch master cylinder, bleed clutch system.