New Beetle GL L4-2.0L (AZG) (2002)
/Page-883004.png)
1- Transmission housing
2- Bolt
3- Differential cage
^
Bolt to final drive gear
4- Final drive gear
^
Riveted in production
^
Pressing off, Refer to Fig. 8
^
Installation position: machined side faces toward bolting surface of differential housing
^
Heat to 100°C before installing
^
Fit to differential housing
^
Bolted, Refer to Fig. 10
5- Backing plate
6- Nut, 40 Nm and turn 45° further
7- Clutch housing
8- Shim
^
For differential
9- Tapered roller bearing outer race
^
Pulling out, Refer to Fig. 5.
^
Pressing in, Refer to Fig 6.
10- Tapered roller bearing inner race
^
Pulling off, Refer to Fig. 3
^
Pressing on, Refer to Fig. 4
11- Differential housing
^
With riveted final drive gear
^
When replacing final drive gear drill out rivet heads
^
Attaching final drive gear with bolts, Refer to Fig. 10
12- Tapered roller bearing inner race
^
Pulling off, Refer to Fig 3
^
Pressing on, Refer to Fig 4
13- Tapered roller bearing outer race
^
Pulling out, Refer to Fig. 1
^
Pressing in, Refer to Fig. 2.
14- Shim
