New Beetle GL L4-2.0L (AZG) (2002)
Fig. 6 Pressing off sleeve -A- over reverse gear wheel
Fig. 7 Pressing off reverse gear synchro-hub
A - Separating device 22 to 115 mm, e.g. Kukko 17/2
Fig. 8 Pulling off tapered roller bearing inner race
^
Before mounting extractor, set thrust plate 30-11 on output shaft.
Fig. 9 Installation position of reverse gear synchro-hub
Reverse gear locking collar stop (arrow -A-) faces toward toothing of output shaft (arrow -B-).