New Beetle GLS L4-1.8L Turbo (AWV) (2001)
<-- Remove clamp -3- and disconnect intake air hose from mass air flow sensor
<-- If applicable, remove secondary air hose -4- from air filter box -5-
<-- Remove screws -6- securing air filter box and remove air filter box
^
If applicable, remove and move aside secondary air relay box and harness from supporting clip
^
If applicable, disconnect electrical connector on brake fluid reservoir
<-- Release ABS control module electrical connector by pulling latch upward -arrow 1-
<-- Pull electrical connector off ABS control module -arrow 2-
^
Raise vehicle and connect brake bleeder bottle to left front brake caliper and left rear caliper bleed screw and open bleed screws
^
Lower vehicle
^
Obtain brake pedal depressor device VAG 1869/2 and place in position in vehicle
^
Slowly depress and hold the brake pedal at least 60 mm (2.36 in.) with brake pedal depressor
^
Raise vehicle
^
Close left front and left rear caliper bleed screws when brake fluid stops flowing
^
Lower vehicle
^
Do not remove brake pedal depressor from brake pedal at this time
Note:
By holding the brake pedal in a down position, the master cylinder central valves are closed and brake fluid does not leak out of system
^
Place sufficient lint-free cloths under the ABS control module and hydraulic unit