New Beetle GLS L4-1.8L Turbo (AWV) (2001)
-
Press buttons -0-, -9- and -4- for "Display group number 94" and confirm entry with -Q- button.
Indicated on display: (1 to 4 = Display zones)
-
Set engine speed to 1800 to 2200 RPM using speed regulator VAG1788/10:
-
Maintain engine speed at 1800 to 2200 RPM until display in display zone 3 jumps from
"Test OFF" to "Test ON".
-
Continue to maintain speed at 1800 to 2200 RPM until specification
"Syst. OK" appears in display zone 3.
If the display does not indicate as described:
-
Remove engine speed adjuster VAG1788/10 from accelerator pedal.
-
Press --> button.
Indicated on display
-
Press buttons -0- and -6- for function "End output" and confirm entry with -Q- button.
-
Switch ignition off.
If "Syst. "nOK" appears in display zone 3:
-
Read DTC memory.
If the DTC 17927 appears, it may be because:
The camshaft adjuster solenoid valve correctly switches oil pressure to the mechanical camshaft adjuster but it cannot reach its end position (e.g.
tight/partially seized).
-
Replace camshaft adjuster.
-
Check DTC memory:
-
Read readiness code:
If the DTC memory has been erased or the Engine Control Module separated from permanent (battery) positive, the readiness code must be generated
again.