New Beetle GLS L4-1.8L Turbo (AWV) (2001)
Crankshaft Main Bearing Seal: Service and Repair
Sealing flanges and drive plate, removing and installing
Note: For repairs to the clutch, Refer to Transmission and Drivetrain, Clutch
1. 90 Nm + 1/4 turn (90°) further
^
Always replace
^
Counter-hold with 3099 to loosen and tighten
^
Threads and shoulder must be free of oil and grease
^
When bolting on, place two washers between toothed belt pulley and counterhold
2. Crankshaft toothed belt sprocket
3. 15 Nm
4. Oil seal
^
Replacing, Refer to Seals and Gaskets, Engine, Front Crankshaft Seal, Service and Repair.
5. Sealing flange
^
Must be located on dowel sleeves
^
Removing and installing, Refer to Timing Cover, Front Sealing flange, removing and installing
6. Cylinder block
^
Removing and installing crankshaft, Refer to Crankshaft, Engine, Service and Repair
^
Disassembling and assembling pistons and connecting rods, Refer to Piston,Engine, Service and Repair
7. 60 Nm +1/4 turn (90°) further
^
Always replace
8. Flywheel/drive plate
^
To remove and install flywheel counterhold with 3067
^
Removing and installing drive plate, Refer to Transmission and Drivetrain, Flex Plate, Service and Repair
9. Intermediate plate
^
Must be located on dowel sleeves
^
Do not damage/bend when assembling
10. Sealing flange with oil seal
^
Only replace complete
^
Remove oil pan to be able to remove and install, Refer to Oil Pan, Service and Repair