New Beetle GLS L4-1.8L Turbo (AWV) (2001)
-
vehicles with an automatic transmission can lean to one side slightly.
-
This is due to the installation position of the assemblies and their associated weight transfer and is normal.
-
If vehicle leans to one side, measure dimension -a- on left and right-hand sides.
-
Correct differences if necessary:
-
On front axle, compensate by adding weight to top of relevant strut tower.
-
On rear axle, compensate by adding weight to relevant side of luggage compartment.
-
Sand bags weighting approximately 10 kg (22 lbs) are suitable.
Explanation of the factory codes
-
Different suspension versions are available as optional equipment. These are identified by the factory codes.
-
The suspension version installed in a vehicle is indicated on the vehicle data label with the relevant factory code.
-
The vehicle data label is located:
-
In the service booklet.
-
Vehicles through 03.00: In spare wheel well.
-
Vehicles from 04.00: Next to spare wheel well near left rear wheel housing.
The following table explains the factory codes. This is relevant for the vehicle alignment.
Wheel alignment specifications
Front Axle