New Beetle GLS L4-1.8L Turbo (AWV) (2001)
Testing and Procedures/Read Measuring Value Blocks (Function 08)/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If indication remains at approx. 143 degrees C:
-
End diagnosis and switch ignition off.
-
Check wires according to wiring diagram.
Checking wiring
-
Connect test box to control module wiring harness, connect test box for wiring test.
-
Disconnect connector -1- from Intake Air Temperature (IAT) Sensor -G42- -2-.
-
Check wires between test box and 2-pin connector -1- for open circuit according to wiring diagram.
Terminal 1 + socket 85
Terminal 2 + socket 108
Wire resistance: max. 1.5 ohms
-
Also check wires for short circuit to each other, to vehicle Ground (GND) and to B+.
Specified value: Infinite Ohms
If no malfunctions are found in wire:
-
Measure resistance at Intake Air Temperature (IAT) Sensor -G42-.
-
Range A displays resistance values for the temperature range of 0...50 degrees C, range B displays resistance values for the temperature range of
50...100 degrees C.