New Beetle GLS L4-1.8L Turbo (AWV) (2001)
If the specification is obtained:
-
Press -> button.
-
Press buttons -0- and -6- for function "End output" and confirm entry with -Q- button.
-
Switch off ignition.
Continuation:
If the specifications are not obtained:
-
Press -> button.
-
Press buttons -0- and -6- for function "End output" and confirm entry with -Q- button.
-
Switch off ignition.
Checking resistance of Knock Sensors (KS)
-
Disconnect 2-pin harness connector to Knock Sensor (KS) 1 -G61- (item no. 1) and/or 2-pin harness connector to Knock Sensor (KS) 2 -G66-
(item no. 2).
-
Measure resistance between the terminals 1 + 2 at connections to Knock Sensors (KS).
Specification: Infinity Ohms
If the specification is not obtained:
-
Replace Knock Sensors (KS) -G61- or -G66-, item 12 or item 13.
-
Check DTC Memory, if necessary, repair any malfunctions and then Erase DTC Memory , Checking and Erasing DTC Memory. See: Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
-
Read readiness code. If DTC memory has been erased or Engine Control Module was disconnected from battery positive, readiness code must be