New Beetle GLS L4-1.8L Turbo (AWV) (2001)
Test requirements
-
The respective fuses of Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) -G130- must be OK.
-
Battery voltage must be at least 11.5 volts.
-
All electrical consumers such as, for example, lights and rear window defroster must be switched off.
-
Parking brake must be engaged or else daylight driving lights will be switched on.
-
If vehicle is equipped with an A/C system, it must be switched off.
-
Ground (GND) connections between engine and chassis must be OK.
-
Exhaust system must be properly sealed between catalytic converter and cylinder head.
-
Coolant temperature must be at least 80 degrees C, Diagnostic mode 1: Check measuring values; PID 5, Coolant temperature. See: Testing and
Inspection/Scan Tool Testing and Procedures/Read Measuring Value Blocks (Function 08)/With Generic Scan Tool/Diagnostic Mode 1: Check
Measured Values
-
Oxygen sensor heater for oxygen sensors behind catalytic converter must be OK, check. See: Testing and Inspection/Component Tests and
General Diagnostics/Oxygen Sensor Heater After Three-Way Catalytic Converter (TWC), Checking
Function test
-
Select the following output of oxygen sensor signals and check whether the specified values are being reached, Diagnostic mode 5: Check output
of oxygen sensor signals. See: Testing and Inspection/Scan Tool Testing and Procedures/Read Measuring Value Blocks (Function 08)/With
Generic Scan Tool/Diagnostic Mode 5: Check Output of Oxygen Sensor Signals
-
Check the specified values of the output of oxygen sensor signals at idle:
If specified values are obtained:
-
End diagnosis and switch ignition off.
If specified values are not obtained:
-
End diagnosis and let engine continue to run at idle.
-
Check primary voltage.
Checking primary voltage
-
Disconnect 4-pin harness connector (brown) to Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) -G130-.