New Beetle GLS L4-1.8L Turbo (AWV) (2001)
-
Screw bolt 2085/1 into camshaft onto stop by hand, to guide seal extractor.
-
Unscrew inner part of oil seal extractor 2085 two turns (approximately 3 mm) out of outer part and lock in position with knurled screw.
-
Lubricate threaded head of oil seal extractor, place it in position and exerting firm pressure screw it into oil seal as far as possible.
-
Loosen knurled screw and turn inner part of extractor against camshaft until oil seal has been extracted.
Installing
Note: Gradual introduction of PTFE oil seal (identifying characteristics: no annular spring, sealing lip wider). The sealing lip of this oil ring must not
be oiled or lubricated. A plain encased seal of older construction (with annular spring) may be replaced with a PTFE oil seal, but not vice versa.
Installing PTFE seal
-
Remove oil remains from crankshaft journal with a clean cloth.
-
Install guide sleeve T10071/5 onto camshaft journal.
-
Slide oil seal over guide sleeve.