New Beetle GLS L4-1.8L Turbo (AWV) (2001)
Rapid data transfer
HELP
Select function XX
NOTE: The next time the ignition is switched "on " the identification of the engine control module is read by the immobilizer control module and
stored.
From 6.01
Replacement Engine Control Module (ECM), adaptation (function 10)
NOTE:
-
The Engine Control Module (ECM) is adapted to the electronic controls of the immobilizer in the instrument cluster. For replacement of
component, a new adaptation must be performed.
-
If there are no authorized ignition keys available, new ignition keys must be prepared and adapted.
-
Secret number must be available, if not, see "Determining secret number".
-
Adaptation can be interrupted using the ¨C" button of the VAG 1551 scan tool.
Requirements
Authorized key available.
NOTE: If all components are being replaced, a new key set must be used.
-
Insert old (authorized) key into ignition lock.
-
Connect VAG 1551 Scan Tool (ST), switch on ignition, select operating mode 1 "Rapid data transfer" and enter address word 01 for "engine
electronics".
Indicated on display (example only)
038906018M.9L R4 EDC 00AG 1813
->
Coding XXXXX WSC XXXXX
Display indicates control module identification and coding, e.g.:
-
038906018M - Part No. of control module (for current control module version, see parts catalog)
-
1.9 L - Engine displacement
-
R4 - Engine type (4-cyl)
-
EDC = Injection system identification (Electronic Diesel Control)
-
G - cruise control system enabled
No display = cruise control system not enabled
-
AG = Automatic Transmission
SG = Manual Transmission
-
1813 = Software version
-
Coding xxxxx = Control module coding
-
WSC xxxxx = Factory identification from the VAG1551 Scan Tool (ST), with which the last coding was performed (if factory coding has not
been changed, WSC 00000 will be displayed)
-
Press button.
Indicated on display:
XXXXXXXXXXXXXXXXX XXXXXXXXXXXXXXX->
r Upper line: Vehicle Identification line Number (VIN),( 17-digit, WVW ....)Identification number,(14-digit, VW....)
For new control modules, place holders are indicated before adaptation instead of the Vehicle Identification Number (VIN) and the identification number
of the immobilizer.
NOTE:
-
If an Engine Control Module (ECM) is being installed that has already been adapted to a different immobilize, it must first be unlocked via the
Login Procedure.
-
The secret number must be determined via the 14-digit identification number of this Engine Control Module (ECM). Continue as follows after
successful Login Procedure: