New Beetle GLS L4-1.8L Turbo (AWV) (2001)
-
Disconnect 5-pin connector -1- from Mass Air Flow (MAF) sensor -2-.
-
Connect multimeter to terminal 2 of connector and engine Ground (GND) for voltage measurement.
-
Start engine, and let run at idle.
Specified value: 11.0 to 15.0 V
-
Switch ignition off.
If there is no voltage:
-
Check wire connection from terminal 2 to Fuel Pump (FP) Relay -J17- according to wiring diagram.
If voltage supply and wires are OK:
-
Switch ignition on.
-
Connect multimeter to terminal 4 of connector and engine Ground (GND) for voltage measurement:
Specified value: 4.5 to 5.5 V
If there is no voltage:
-
Switch ignition off.
-
Check signal and ground wires.
Checking Signal And Ground Wires Of Mass Air Flow (MAF) Sensor
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring
Test
Engine Control Module (ECM) is not connected.