New Beetle GLS L4-1.8L Turbo (AWV) (2001)
Control Module: Service and Repair
The control module (arrow) is located in the plenum chamber, center right.
Removing TCM -J217-
^
Switch off ignition.
^
Remove inner cover of plenum chamber.
^
Disconnect multi-pin connector, then remove connector from control module.
^
Remove screws (arrows).
^
Remove control module.
Installing TCM -J217-
Install the TCM in the reverse order of removal and note the following:
^
Locate multi-pin connector on TCM -J217- pins (arrows) then lock connector.
^
Perform On Board Diagnostic (OBD).
^
Initiate basic setting.