New Beetle GLS L4-2.0L (AVH) (2001)
-
Open hood and place fender cover in position
-
Disconnect the ground cable (GDN) from the negative (-) battery terminal
-
Disconnect electrical connector -1- from mass air flow sensor -2-
-
Remove vacuum line -7- attached to lower corner of air box (TDI vehicles only)
-
Remove clamp -3- and disconnect intake air hose from mass air flow sensor
-
If applicable, remove secondary air hose -4- from air filter box -5-
-
Remove screws -6- securing air filter box and remove air filter box
-
If applicable, remove and move aside secondary air relay box and harness from supporting clip
-
If applicable, disconnect electrical connector on brake fluid reservoir
-
Release ABS control module electrical connector by pulling latch upward -arrow 1-
-
Pull electrical connector off ABS control module -arrow 2-
-
Raise vehicle and connect brake bleeder bottle to left front brake caliper and left rear caliper bleed screw and open bleed screws
-
Lower vehicle
-
Obtain brake pedal depressor device VAG 1869/2 and place in position in vehicle
-
Slowly depress and hold the brake pedal at least 60 mm (2.36 in.) with brake pedal depressor
-
Raise vehicle
-
Close left front and left rear caliper bleed screws when brake fluid stops flowing
-
Lower vehicle
-
Do not remove brake pedal depressor from brake pedal at this time
NOTE: By holding the brake pedal in a down position, the master cylinder central valves are closed and brake fluid does not leak out of system
-
Place sufficient lint-free cloths under the ABS control module and hydraulic unit