New Beetle GLS L4-2.0L (AVH) (2001)
^
For bearing cap without oil groove
^
For cylinder block with oil groove
^
Do not interchange used bearing shells (mark)
8. Sensor wheel
^
Always replace
^
For Engine Speed (RPM) Sensor G28
^
Can only be installed in one position, holes are off-set.
^
Installing, Refer to Fig. 1
9. 10 Nm (7 ft. lbs.) plus additional 90° (1/4 turn)
^
Installing
^
Always replace
^
90 ° additional angle can be measured with torque angle meter i.e., Hazet 6690
10. Thrust washer
^
For bearing 3 bearing cap
^
Note installation arrangement
11. Crankshaft
Axial clearance:
^
New: 0.07...0.23 mm
^
Wear limit: 0.30 mm
Check radial clearance with Plastigage
^
New: 0.01 0.04mm
^
Wear limit: 0.15 mm
^
Do not rotate crankshaft when checking radial clearance
^
Crankshaft dimensions, Refer to Crankshaft Engine,Specifications
12. Cylinder block
^
Pistons and connecting rods, disassembling and assembling, Refer to Piston, Service and Repair
Fig. 1 Sensor wheel, installing on crankshaft
Mounting surfaces of sensor wheel and crankshaft must be free of grease and oil.
-
Install mounting bolts by hand
-
Torque to 10 Nm (7 ft. lbs.) plus additional 90° (1/4 turn )