New Beetle GLS L4-2.0L (AVH) (2001)
-
No cable disc for accelerator cable as this is an electronic accelerator system
-
6- pin connector
-
Terminals gold plated
5
-
Oxygen sensor 1 before catalyst -G39-*, 50 Nm
-
Fitting location: In exhaust manifold
-
Grease only the threads with Part No. G 052 112 A3 hot bolt paste (anti-seize compound). Grease must not get into the slots on the sensor
body
6
-
6-pin connector
-
Black: for Heated Oxygen Sensor (HO2S) -G39- and Oxygen Sensor (O2S) heater -Z19-
-
Terminals gold plated
-
Right on underside of vehicle
CAUTION : Part numbers are for reference only. Always check with your Parts Dept. for the latest parts information
7
-
Oxygen sensor 2 after catalyst -G130-*, 50 Nm
-
Location: in rear of catalyst
-
Grease only the threads with Part No. G 052 112 A3 hot bolt paste (anti-seize compound). Grease must not get into slots on the sensor
body
8
-
4-pin connector
-
Brown: for O2S Behind TWC -G130- and O2S heater 1 -Z29-
-
Connector terminals 3 and 4 are gold-plated.
-
Right on underside of vehicle
CAUTION : Part numbers are for reference only. Always check with your Parts Dept. for the latest parts information
9
-
81-pin harness connector
-
Only disconnect or connect with ignition switched off
-
Release to disconnect
10
-
40-pin harness connector
-
Only disconnect or connect with ignition switched off
-
Release to disconnect
11
-
Motronic Engine Control Module (ECM)-J220-*
-
Location: below inner cover of plenum chamber, left side in passenger compartment
12
-
Mass Air Flow (MAF) sensor -G70-* with intake air temperature sensor -G42-*
-
Terminals gold plated
13
-
Secondary air pump motor relay -J299-*/**
-
Secondary air System:
14
-
Air cleaner
15
-
Main fuses
-
for additional protection
16
-
Positive Crankcase Ventilation (PCV) Heating Element - N79-
17
-
Engine - Coolant Temperature (ECT) sensor -G62- *
-
If necessary release pressure in cooling system before removing
18
-
Ignition coils with power output stage -N70-, -N127-, -N291-, -N292-
19
-
Injectors -N30- to -N33-*/**
-
Air shrouded
20
-
10 Nm
21
-
Engine speed sensor -G28-*
22
-
O-Ring
-
Replace if damaged
23
-
20 Nm
-
Tightening torque influences function of knock sensor
24
-
Knock sensor 2 -G66-*
-
Black: 2- pin
-
Terminals gold plated
25
-
2 pin- Connector
-
for Knock sensor 2 -G66-
-
Black
-
Mark connector before disconnecting
26
-
Secondary air pump motor -V101-*
-
Secondary air system:
27
-
Knock sensor 1 -G61-*
-
Terminals gold plated
28
-
2 pin - Connector
-
for Knock sensor 1 -G61-
-
Black