New Beetle GLS L4-2.0L (AVH) (2001)
-
Check wiring for open circuit between test box and 5-pin connector using wiring diagram.
-
Terminal 5 + socket 29
-
Terminal 4 + socket 53
-
Terminal 3 + socket 27
Wire resistance: Max. 1.5 Ohms
-
Additionally check wires all for short to one another.
Specification: Infinity Ohms
-
Check wiring additionally for short circuit to battery positive/Ground.
If no wiring problem is detected:
-
Replace Mass Air Flow (MAF) sensor (G70).
-
Check DTC memory, if necessary, repair any malfunctions and then erase DTC memory. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
-
Read readiness code. If DTC memory has been erased or engine control module was disconnected from permanent positive, readiness code must
be generated again. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes See:
Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes