New Beetle GLS L4-2.0L (AVH) (2001)
-
Set multimeter to measure resistance and check sensor heating resistance at connector to oxygen sensor terminals 3 + 4
Specification: 2.5 to 10 Ohms (at room temperature).
If the specification is not obtained:
-
Replace oxygen sensor before catalyst (G39).
-
Check DTC memory, if necessary, repair any malfunctions and then erase DTC memory. Refer to "Displaying and Reading Trouble Codes/With
Manufacturers Scan Tool/DTC Memory Checking and Erasing" See: Computers and Control Systems/Testing and Inspection
If the oxygen sensor has continuity:
-
Set multimeter to measure voltage and connect to terminal 3 (connector to engine control module) and Ground.
-
Start engine and run at idle speed.
-
Measure voltage supply:
Specification: 11.0 to 14.5 V
If the specification is not obtained:
-
Check wiring between terminal 3 and fuel pump relay (J17) using wiring diagram.
If the specification is obtained:
Checking voltage supply