New Beetle GLS L4-2.0L (AVH) (2001)
increased and hunting idle speed. The engine reacts slowly to accelerator changes.
Indicated on display: (1 to 4 = display zones)
Basic setting 60
->
xxx%
xxx% 8
ADP.OK.
Adapting has been performed successfully.
-
End engine basic setting by pressing -> button.
-
Press buttons 0 and 6 for function "End output" and confirm entry with Q button.
To store the values:
-
Switch ignition off for at least 50 seconds (control module run-on).
-
Switch ignition off.
NOTE:
If the basic setting of the control module is interrupted, the cause could be one of the following:
-
The test conditions were not fulfilled.
-
Throttle valve control module is malfunctioning or there is a malfunction in the wiring.
After an interruption a DTC is stored in DTC memory. When next switching on ignition the basic setting is automatically performed again.