New Beetle GLS L4-2.0L (AVH) (2001)
NOTE:
-
On replacement part, same strap must not be separated from cushion under any circumstance.
-
To ease reassembly, note how heating element wires are routed.
-
Remove heating element from seat cushion. Carefully separate both parts.
-
Cut clips - arrows -.
-
Disconnect sensor harness connector - 1 -.
-
Disconnect harness connector for belt tensioner sensor. Press connector downward and then inward to do so - arrow -.
-
Disconnect harness connector - 2 - and loosen from holding position.
-
Remove electrical wires from securing clips if necessary - 3 -
NOTE:
-
Release locking mechanism on upper side of harness connector - 1 - of control module to reconnect replacement part.
-
Before removing electrical wires from securing clips - 3 -, note routing and connection.
-
Remove electrical wires from securing clips if necessary.
NOTE: Before removing electrical wires from securing clips, note routing and connection.
-
Remove hose clips - arrows - from bracket.
NOTE:
-
Before removing clips, check whether replacement part includes clips, otherwise reuse clips.
-
If hose clips are missing, attach replacement hose properly to route hose as depicted in illustration.