New Beetle GLS L4-2.0L (AVH) (2001)
Continuation of test if indication is approx.. -40.0 degrees C:
-
Disconnect 4-pin connector from Engine Coolant Temperature (ECT) Sensor -G62- with Engine Coolant Temperature (ECT) Sensor -G2- (arrow).
-
Bridge terminals 3 + 4 of connector using the respective adapter cables and observe the indication on display.
If indication jumps to approx.. 140.0 degrees C:
-
End diagnosis and switch ignition off.
-
Replace Engine Coolant Temperature (ECT) Sensor -G62-:
-
Vehicles with engine code AVH, AZG, item 17,
-
Vehicles with engine code BDC, item 15.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles
and Readiness Codes
If indication remains at approx.. -40.0 degrees C:
-
End diagnosis and switch ignition off.
-
Check wires according to wiring diagram.
Continuation of test if indication is approx.. 140.0 degrees C: