New Beetle GLS L4-2.0L (AZG) (2002)
-
Connect multimeter for voltage measurement to terminals 3 + 4 of connector to Engine Control Module (ECM) and measure primary voltage.
Specified value: 0.400 to 0.500 Volts
-
Switch ignition off.
If specified value is not obtained:
-
Test oxygen sensor wires.
If specified value is obtained:
-
Replace Oxygen Sensor (O2S) 2 Bank 1 Behind Three Way Catalytic Converter (TWC) -G130-:
-
Vehicles with engine code AEG, item 10,
-
Vehicles with engine code AVH, AZG, BDC, item 11.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
Checking oxygen sensor wires
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring
Test
Vehicles with engine code AEG
-
Check wires between test box and 4-pin connector (to control module) for open circuit according to wiring diagram.
-
Terminal 3 + socket 51
-
Terminal 4 + socket 52
-
Wire resistance: max. 1.5 Ohms
Vehicles with engine code AVH, AZG, BDC