New Beetle Turbo S L4-1.8L Turbo (AWP) (2002)
If there is no voltage:
-
Check wire between 4-pin connector terminal 1 and Motronic Engine Control Module (ECM) Power Supply Relay (main relay) for open circuit
according to wiring diagram.
Wire resistance: max. 1.5 ohms
-
Check wires between 4-pin connector and Ground (GND) for open circuit according to wiring diagram.
Terminal 2 and Ground (GND)
Terminal 4 and Ground (GND)
Wire resistance: max. 1.5 ohms
Vehicles with engine code AWP, AWV
-
Disconnect 4-pin connector -2- from ignition coil -1- to be checked.
-
Measure supply voltage between terminals
-
Switch on ignition.
Specified value: at least 11.5 V
-
Switch ignition off.
If there is no voltage:
-
Check wire between 4-pin connector terminal 1 and Motronic Engine Control Module (ECM) Power Supply Relay (main relay) for open circuit