volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Sensors and Switches - HVAC > < Oil Pressure Sender|Testing and Inspection
Page 2
background image

^

If the oil pressure switch is closed, the warning lamp will remain switched on if the engine speed is above 5000 RPM. The warning lamp will
be switched off again if the engine speed is below 5000 RPM.

^

If the oil pressure switch is open for 0.3 - 3.0 seconds when the engine speed is above 1500 RPM, it will be stored in the combi-processor in
the instrument cluster. If this condition occurs three times when the engine is running, the oil pressure warning will be activated and will not be
cancelled even below 1500 RPM. The oil pressure warning will be cancelled when the oil pressure switch is closed for longer than 5 seconds
at an engine speed above 1500 RPM, or when the ignition is switched off.

Test conditions
^

Engine oil level OK, Refer to Lubrication System Components, removing and installing, Refer to Fig. 1. Markings on oil dipstick

^

Oil Pressure Warning Lamp -K3- must light up for approximately 3 seconds when ignition is switched on

^

Engine oil temperature at least 80° C (radiator fan must have run once)

Test sequence
-

Remove Oil Pressure Switch -F1- and screw into tester.

-

Screw tester into oil filter bracket in place of oil pressure switch.

-

Connect brown wire of tester to Ground (-).

-

Connect LED test light VAG 1527 B using aux. cables from VAG 1594 A to battery positive (+) and oil pressure switch.
LED must not light up.

-

If LED lights up, replace 1.4 bar Oil Pressure Switch -F1-.

When the LED does not light up:
-

Start engine and run at idling speed:
At 1.2-1.6 bar LED must light up, otherwise replace oil pressure switch.

-

Check oil pressure at different RPMs:
^

Idle: at least 2.0 bar

^

2000 RPM: 2.7 to 4.5 bar

^

Above 2000 RPM: maximum 7.0 bar

If the specifications are not obtained:
-

Repair mechanical damage (e.g. bearing damage).

-

Replace oil filter bracket with pressure relief valve.

At higher engine speeds the oil pressure must not exceed 7.0 bar.
If the specification is exceeded:
-

Check oil galleys.

-

If necessary, replace oil filter bracket with pressure relief valve.

Sensors and Switches - HVAC > < Oil Pressure Sender|Testing and Inspection