Passat L4-1.8L Turbo (AWM) (2004)
/Page-2151001.png)
Drive/Propeller Shaft: Adjustments
01E Manual Transmission
Driveshaft, adjusting
Special tools and equipment
^
3139 Assembly device for driveshaft
^
3139/3 Spacers
^
VAG 1331 Torque wrench
-
Remove front cross support below exhaust system, if equipped.
-
Remove rear section of exhaust system.
-
Remove heat shield from vehicle floor.
Driveshaft with 60 mm tube diameter front and rear
Note: Do not set assembly tool over balancing weights.