Passat L4-1984cc 2.0L DOHC (1991)
5
-
Wire cross-section size (in mm2) and wire colors
See chart above for wire size conversion to American Wire Gauge (AWG). Wire color abbreviations are explained in color code chart on each
page of the wiring diagram.
6
-
Component designation (code)
Use legend at bottom of page to identify the component code.
7
-
Internal connections (thin lines)
These connections are not always wires. Internal connections are current carrying and are listed to allow tracing of current flow inside
components and wiring hamesses.
8
-
Wire harness ground connection
Locations of ground connections are indicated in the legend.
9
-
Relay/control module connectors on fuse/relay panel
Shows the individual terminals in a multi-point connector. Example: 4/30
4 = contact 4 at location [3] on relay panel or relay carrier
30 = terminal 30 (B+) on relay/control module
10
-
Relay location number
Indicates relay location on fuse/relay panel.
11
-
Fuse/relay panel connectors
Shows wiring of multi-point or single connectors on fuse/relay panel.
Example: G1/10 = multi-point connector G1, terminal 10
12
-
Terminal designation
Designation which appears on actual component and/or terminal number of a multi-point connector.
13
-
Wire continuation (current track number)
Number in frame indicates current track where wire is continued.
14
-
Continuation of internal connections
Letters indicate where connection continues on the previous and/or next page.
15
-
Component symbols (see page IV and V)
16
-
Wiring harness wire connection
Locations of wire connections are indicated in the legend.
17
-
Arrow
Indicates component is continued on the previous and/or next page.
18
-
Circuit Identification (Fuse/Relay Panel)
1
- Ignition coil/ignition distributor low voltage (typically used as an Engine Speed (RPM) signal for the tachometer)
15
- Switched Battery Positive Voltage (B+) from ignition/starter switch
30
- Battery Positive Voltage (B+), hot at all times
31
- Ground (GND)
50
- Starter control; switched B+ from ignition/starter switch
56
- Switched headlight B+ from light switch
58
- Switched parking light, taillight. illumination B+ from light switch
S (SU) - Key In ignition circuit: switched B+ from ignition/starter switch
X
- Load reduction circuit; switched B+ from load reduction relay
Wiring Diagram Circuit Identification
Wiring Diagram Terminal (circuit) Identification
Several wiring circuits in the vehicle's electrical system are identified with a number or letter designation. These circuits are identified the same in
all wiring diagrams and are most commonly shown near the top of each page in the fuse/relay panel portion of the wiring diagram. The circuit
designations may also be used to identify switch connector terminals (switch circuits). Following are the most common numbered/lettered circuits: