Passat L4-1984cc 2.0L DOHC (1991)
Throttle Body: All Technical Service Bulletins
M/T Throttle Valve Housing Clip - Installation
Group:
24
Number:
92-04
Date:
March 31, 1992
Subject:
16V 2L Manual Transmission Throttle Valve Housing Clip Installation
Model(s):
Jetta GLI, GTI with 16V, GTX (in Canada) and Passat, 1990, 1991 m.y.
Condition
Manual transmission vehicles have a throttle valve housing which may have delay between the actuation of the idle switch and the actuation of the
primary throttle plate.
Criteria
A 2 mm gap (see illustration 25-A284) may exist between the idle switch actuation lever and the throttle plate. This gap may cause a hesitation on the
take off and/or reduced responsiveness at steady speeds.
To eliminate gap, a clip, Part No. 051 133 806 A, see Fig. 25-A285, is to be installed on the actuator arm.
CAUTION
DO NOT install clip when no gap is present.
^
check idle switch operation per Repair Group 25 Service Microfiche, replace if necessary
^
install clip, Part No. 051 133 806 A (Fig. 25-A286) in direction of arrow
^
use needle nose pliers