Passat V6-3.6L (BLV) (2006)
^
Disconnect parking aid sensors by gently separating parking aid sensor retaining tabs and sliding sensor out of retainer.
^
Inspect sensor terminals and wiring harness connector terminals of all sensors (front and rear) for corrosion, clean as necessary.
If corrosion is too severe:
^
Replace sensor, wiring harness connector and terminals.
NOTE:
Pay close attention to the positioning of the sensors and their associated index number. Sensors of the same index number MUST be placed back into
their original position.
^
Inspect and record index numbers of all sensors:
Replace any sensor with an index letter -arrow- below " K" -front bumper center sensor- and " L" -front bumper outer sensor and rear bumper sensors-,
see Repair Manual Group 94 Lights, lamps, switches outside, Parking aid.
Tip:
ALL sensors must have a new protective cap installed from Kit # 3C0998277
^
Place grille on a clean and protective surface.
^
Remove parking assist sensor from retainer.