Passat V6-3.6L (BLV) (2006)
‹› In the event the repair point was previous taped, this point must be taped anew with yellow insulating tape after repairs.
‹› Secure the repaired wiring harness if necessary with a cable tie to prevent flapping noises while driving.
Contacts In Contact Housing, Repairing
Contacts in Contact Housing, Repairing
-
First, open or release if necessary the secondary lock of the contact housing. Refer to => [ Secondary Lock ] See: Description and
Operation/Secondary Lock.
-
Release contact (primary lock) using the appropriate release tool. Refer to => [ Primary Lock ] See: Description and Operation/Primary Lock.
-
Pull contact at single wire out of contact housing.
-
Take the yellow repair wire with the correct contact out of the wiring harness repair set.
-
Free up repair point of vehicle-specific wiring harness (approximately 20 cm to both sides of repair point).
-
If required, remove wiring harness wrapping using a folding knife.
-
Insert new contact of repair wire into contact housing until it engages.