Passat GLS L4-1.8L Turbo (AUG) (2001)
/Page-578002.png)
^
Do not interchange run-in connecting rod bearing shells (mark)
8- Needle bearing
^
Only vehicles with manual transmission
^
Removing and installing, Refer to Clutch, M/T.
9- Sensor wheel
^
Always replace
^
For Engine Speed (RPM) sensor -G28
^
Installation only possible in one position (bore holes offset)
10- 10 Nm + 1/4 turns (90°) turn
^
Always replace
11- Thrust washer
^
For bearing cover, bearing 3
^
Check locating point
12- Crankshaft
^
Axial play when new: 0.07 to 0.23 mm wear limit: 0.30 mm
^
Measure radial play with Plastigage again: 0.02 to 0.04 mm wear limit: 0.15 mm
^
Do not turn crankshaft when measuring radial play.
^
Crankshaft dimensions, Refer to Specifications.
^
Different version for manual transmission and automatic transmission; observe part number
13- Thrust washer
^
For mounting bracket, bearing 3
^
Check locating point
Fig. 1 Identification on crankshaft bearing, top
In the factory, the upper bearing shells are assigned to the cylinder block with the correct thickness. Colored dots serve for identifying bearing shell
thickness.
Note: Arrow points in direction of travel.
The letters marked on the lower sealing surface of the cylinder block identify which bearing thickness must to be installed in which location.
Color identification
