Passat GLS 4Motion V6-2.8L (ATQ) (2002)
-
Remove bolts - arrows -.
-
Remove door seal - 1 - in area of door lock.
-
Remove cap - 2 -.
-
Remove bolts - 3 -.
-
Remove upper assembly carrier from door, lift and lift out from door toward hinge side of door.
-
Rotate assembly carrier and disconnect harness connector from door lock.
-
Unclip clips for electrical wires from rear side of assembly carrier.
Installing
-
Insert assembly carrier into door.
-
Insert bolts and tighten in specified sequence, tightening torque: 8 Nm.
-
Installing door window, see installing door window to window regulator.