Passat GLS 4Motion V6-2.8L (ATQ) (2002)
-
Unclip clamp for coupling rod -1- for vehicle attitude sensor -G78- from track-control link -2-.
Continued for all vehicles
-
Before loosening subframe, check that at least holes -1- and -2- align using special tool 3393.
If this is not the case, perform axle alignment measurements after installing the sub-frame!
-
Unscrew hex bolt.
-
Unscrew hex nuts -3- and -4- and take out coupling link.
-
Remove hex nut -2- for track-control link on subframe and take out hex bolt.
-
Remove hex bolt -1-.