Passat GLS 4Motion V6-2.8L (ATQ) (2002)
Aligning bonded rubber mounting
The bonded rubber mountings must be aligned with a long square tube or a straight-edge.
A 90° - 5°
Only tension sub-frame in a vice using protective clamps!
Pulling in rear bonded rubber mounting
-
Coat bonded rubber mounting with e.g. tire assembly paste.
-
Pull in mounting -A- until the thrust piece -3372/1- aligns with the upper edge of tool -3372-.
-
Take tool -3372- and segments -3372/2- off upward.
Pulling in rear bonded rubber mounting
-
Insert segments -3372/2- between bridge -3351/4- and sub-frame.
-
Pull mounting -A- in onto stop.