Passat GLS 4Motion V6-2.8L (ATQ) (2002)
Installation location:
The control module is bolted to the hydraulic unit and is located on the left side, in the engine compartment.
WARNING: Do not bend the brake lines in the area of the hydraulic unit!
Removing
^
Vehicles equipped with coded anti-theft radio, note or request radio code if necessary.
^
Disconnect battery.
^
Unscrew coolant expansion tank -2- and place to side with coolant hoses still connected.
Note: The hydraulic unit -1- is turned 180° on the W8.
^
Release control module connector in direction of arrow and pull off.
^
Disconnect connector from brake pressure sensor.
^
Insert VAG 1869/2 brake pedal depressor.
^
Depress brake pedal with brake pedal depressor.
^
Connect bleeder bottle hose to left-front brake caliper bleed screw and open bleed screw.
^
Close left-front bleeder screw.
^
Place lint-free cloths under the control module and hydraulic unit.
Make sure no brake fluid gets onto contacts.
^
Disconnect brake lines on the hydraulic unit.
^
Seal brake lines and threaded holes with plugs from repair kit Part No. 1 HO 698 311 A.
^
Unclip locking clips -1- from below and remove in direction of arrow.