Passat GLS 4Motion V6-2.8L (ATQ) (2002)
/Page-1572007.png)
^
VAG1331 Torque wrench (or equivalent)
^
VAG1410 Torque wrench (or equivalent)
^
VAG1869/2 Brake pedal depressor
Note:
^
After replacing brake pads with vehicle stationary, depress brake pedal firmly several times so that the brake pads are properly seated in their
normal operating position.
^
To draw off brake fluid from the reservoir, use a bleeder bottle which is used only for brake fluid. Brake fluid is poisonous, NEVER siphon
brake fluid with your mouth!
^
Wheel bolt tightening torque
1 - Brake hose
^
Do not disconnect brake hose when changing brake pads
2 - Spring clip
3 - Brake line, 15 Nm
^
Screw into brake caliper housing
^
Screw into brake hose, counter hold hex on brake hose.
^
Make sure that lugs are properly seated in retainer grooves.
4 - Self-locking hex bolt, 35 Nm
^
Replace
^
When loosening and tightening counter hold on guide pin
5 - Ribbed combi bolt, 120 Nm
^
Clean ribs if re-using
6 - Brake carrier with guide pins and protective caps
^
Supplied as assembled replacement part with sufficient grease on guide pins
^
If protective caps or guide pins are damaged use repair kit. Use grease packet supplied to lubricate guide pins.
7 - Brake disc
^
Vented brake disc: diameter 280 mm
^
Brake disc thickness: 22 mm
^
Wear limit: 20 mm
^
Always replace both sides
