Passat GLS 4Motion V6-2.8L (ATQ) (2002)
Electronic Brake Control Module: Service and Repair
ABS control module (w/EDL) -J104- (Bosch 5.3), removing and installing
Removing:
The control unit is located under the right-hand floor carpet on the front passenger's side.
^
Slide right-hand front seat back completely.
^
Remove A pillar trim in right footwell.
^
Pull right-hand side sill panel strip off sill panel.
^
Pull front right floor carpet back until the ABS/ESP control module in area of bulkhead is free.
^
Remove the two securing nuts (arrows).
^
Take out control module with protective housing.
^
Remove protective housing securing screws.
^
Remove control module.
^
Press locking device in direction of arrow to release connector.
Installing:
^
Installation is carried out in the reverse sequence
^
Tightening torque of securing nuts for control module with protective housing to bulkhead is 9 Nm.