Passat GLS 4Motion V6-2.8L (ATQ) (2002)
Brake Light Switch: Adjustments
Brake Light Switch -F- and Brake Pedal Switch -F47-, Adjusting
Brake light switch -F- and brake pedal switch -F47-, adjusting
^
Remove storage compartment on driver's side.
Mounting bracket with internal thread for mounting brake light switch.
1 - Brake light switch
2 - Hex-nut,M12 x 1.5
3 - Brake pedal
Note: A spring washer (not visible in illustration) is installed between nut -2- and mounting bracket.
Before adjusting brake light switch, check whether brake pedal is in end position (released position).
^
Rotate brake light switch in or out (as necessary) to obtain dimension -A- = 0.1 to 0.5 mm.
^
Tighten nut -2- to 4.5 Nm.
^
Install storage compartment on driver's side.
^
Operate brake pedal.
-
Both brake lights light up.
^
Remove foot from brake pedal.
-
Both brake lights must not light up.
Mounting bracket with clip for mounting brake light switch.
1 - Mounting bracket for pedal assembly