Passat GLS 4Motion V6-2.8L (ATQ) (2002)
-
Pry securing clip -arrow- off connector on wiring harness.
-
Pull connector -arrow- off transmission vehicle speed sensor-G38-.
-
Only remove the bolts from the valve body, which are marked with an arrow.
-
The bolt identified by arrow -A- is shorter than the other bolts.
-
Do not remove any other bolts as this could influence the function of the valve body.
-
Detach valve body from transmission and guide out connector on wiring harness.
-
Do not place valve body upside down on sensor for transmission RPM -G182-.
Installing
-
Lubricate new O-rings for connector on wiring harness with ATF.