Passat GLS 4Motion V6-2.8L (ATQ) (2002)
-
Tighten brake servo securing bolts -3- and -4- to 25 Nm
-
Then tighten securing bolt -1- for brake fluid reservoir -2-.
-
Attach connector to brake fluid level sender on brake fluid reservoir.
-
Press in clip -C- to stop.
-
Push line/hose assembly -B- into master cylinder until it audibly engages.
-
Test line/hose assembly by tugging on it.
-
Insert rubber grommet -D- for return hose -A- into bulkhead.
-
Push return hose -A- to stop on connecting line of master cylinder.
-
Remove hose clamp 3094.
-
Tighten securing bolt (-arrow-) for foot pedal cluster to instrument panel carrier to 25 Nm
-
Connect master cylinder to clutch pedal. Engage new pin in clutch pedal.
-
Bleed clutch system after installing master cylinder.
Checking and adjusting clutch pedal switch
-
Clutch pedal is not operated.