Passat GLS 4Motion V6-2.8L (ATQ) (2002)
-
Remove coupling rod from anti-roll bar.
1. Coupling link
-
Remove bolt -A- for track rod.
-
Mark installation position of eccentric washer for bolt -B-.
-
Remove bolt -B-.
-
Remove bolt -2- for control arm -1
-
Pull wheel bearing housing off drive shaft.
Installing
Install in reverse order
-
Install wheels and tighten
After installing check position of steering wheel during a test drive.
If steering wheel is not in straight ahead position, the front axle tracking must be checked!
Tightening torques:
Upper control arm to wheel bearing housing
Lower control arm to wheel bearing housing
Drive shaft to wheel hub
Track rod to wheel bearing housing
Coupling rod to anti-roll bar
Splash plate to wheel bearing housing
Brake caliper to wheel bearing housing