Passat GLS Wagon L4-1.8L Turbo (AUG) (2001)
/Page-2220002.png)
Removing
-
Remove noise insulation.
-
Remove front turn signals.
-
Remove Bowden cable - 6 - from coupling and disconnect electrical harness connectors.
-
Remove front bumper and remove side guide pieces from fender.
-
Disconnect hoses for charge air cooler (only for corresponding engine versions).
-
Drain engine coolant and disconnect coolant pipes.
-
Remove condenser from lock carrier.
-
Remove hydraulic oil cooler from lock carrier.
-
ATF lines must be removed for vehicles with automatic transmission with ATF cooler.
CAUTION: If lines for A/C system and/or for coolant are disconnected, engine must no longer be started.
NOTE:
-
Do not hang condenser and hydraulic oil cooler on hoses.
-
Do not kink condenser and hydraulic line/hoses.
Installing
Installation is reverse of removal.
-
Make sure that all plug- and hose connections are connected when re-assembling.
-
Check ATF level and top off.
-
Align lock carrier at longitudinal and between fenders.
-
Adjust headlights.
Lock Carrier And Front Bumper Reinforcement, Service Position
Lock Carrier And Front Bumper Reinforcement, Service Position --> 09.00
